Product Details
No. 10 Antifouling
Features:
No.10 Antifouling is recommended:
· Where hard wearing season to season effective fouling protection is needed
· On racing yachts that are regularly cleaned
· On power boats, trailer yachts, dinghies etc.
· As a durable boottop for hulls protected with No.5 Ablative Antifouling
No.10 Antifouling is:
· Compatible over other copper based anti-foulings, where recommended preparation is achieved
· Not suitable for use on aluminium craft, outboard motors, sail drives or stern legs
· Suitable and recommended for use on primed GRP, steel, timber and ferro-cement craft
· Cleanable
Download No. 10 Antifouling Data Sheet
Advantages:
Contains No Organotin Compounds
· Proprietary EvoCore~1TM technology increases efficiency and reduces environmentally damaging copper leaching by 30%
· Proprietary leaching matrix binder provides
· Semi-ablative mechanism inhibits the attachment of fouling organisms
· Available in five clean colours
· Minimal colour wash-out when being cleaned
· Suitable for high speed craft and underwater surfaces subject to high turbulence
· Very good static performance
· Very good long term performance
Approvals:
· HSNO (New Zealand) - Hazardous Substance Approval Code HSR000040
· IMO Tin-Free Certified – 20613/A0 BV
Limitations of Use:
Some colour variation between batches may occur, also colours may change during storage. If material from different batches is used, carry out thorough “boxing” to ensure a consistent colour is achieved. Depending on conditions full colour may be developed over the first weeks of immersion.
Do NOT apply to aluminium alloy surfaces.
Specific Data:
Generic Type: Tin-Free Proprietary Matrix
Colour: White, Red, Medium Blue, Dark Blue and Storm Black
Packaging: 4 litre, Single component
Flash Point: 44oC
Thinner: 121 Thinner
Storage: 12 months when stored under cool, dry conditions
Density: 1.9 kg per litre (varies with colour)
Volume Solids: 46% ± 0.5%
Theoretical Coverage Rate: 9.2 sq metres per litre at 50 microns dry
Recommended Film Thickness Per Coat: 109 microns wet to obtain 50 microns dry, Two to three coats recommended, 163 microns wet to obtain 75 microns dry Single coat for 12 months service- approximately
Application: Spray, brush or roller
Dry Times (75 µm DFT / 25oC / 50% RH):
To Recoat Minimum - 4 hours, overnight at 10°C or less
Maximum - Not critical
To Launch Minimum - 8 hours, overnight for films in excess of 150 microns dry thickness
Maximum - Not critical
Home | Site Map | Back to top
Site by MOCA | © 2010 Altex Yacht and Boat Paint. All rights reserved.